The Beaufort Wind Force Scale
3 min read · Energy Atlas Editorial
The Beaufort Wind Force Scale, originally from 0 to 12, helps to estimate the force of the wind by observation of its effects.
In the early 19th century, seamen regularly observed and recorded the weather, but they did not have a standardized objective scale to determine the strength of the wind. A standardized system was introduced by the British naval officer Francis Beaufort in 1806. Originally, the scale had 13 numbers (0 to 12). The numbers did not correspond to measured wind speeds but described the force of the wind based on observed conditions. At 0 all sails would be up, at 6 about half the sails would have to be taken down, and at 12 all the sails would have to be stowed away.
Wind speeds, as measured by an anemometer, and descriptions of the effects of wind at sea and on land were later incorporated into the scale. This made it possible to estimate wind force and the corresponding wind speed from observed conditions without using measuring instruments. In the middle of the 20th century, five further numbers were added for extreme winds, but the standard Beaufort scale used today ranges from 0 to 12.
The Beaufort Wind Force Scale Table
Beaufort number · Wind · Speed [km/h] · Land conditions · Wave height [m] 0. · Calm · < 1 · Smoke rises vertically · < 0.1 1. · Light air · 1—5 · Direction of wind shown by smoke but not by wind vanes · about 0.1 2. · Light breeze · 6—11 · Wind felt on face, leaves rustle, ordinary vane moved by wind · about 0.2 3. · Gentle breeze · 12—19 · Leaves and small twigs in constant motion, wind extends light flag · 0.6 4. · Moderate breeze · 20—28 · Wind raises dust and loose paper, small branches are moved · 1.0 5. · Fresh breeze · 29—38 · Small trees begin to sway, wavelets form on inland waters · 2.0 6. · Strong breeze · 39—49 · Large branches in motion, whistling heard in wires, umbrella use difficult · 3.0 7. · Near gale · 50—61 · Whole trees in motion, inconvenience felt when walking · 4.0 8. · Gale · 62—74 · Twigs break off trees; generally impedes progress · 5.5 9. · Strong gale · 75—88 · Slight structural damage occurs, chimney pots and slates removed · 7.0 10. · Storm · 89—102 · Seldom experienced inland, trees are uprooted, considerable structural damage occurs · 9.0 11. · Violent storm · 103—114 · Very rarely experienced on land, accompanied by widespread damage · 11.5 12.—17. · Hurricane · > 117 · Countryside is devastated · > 14
Keep reading
Articles
The Energy of Flowing Air
The movement of air masses between two differently warm places is called a wind. Most wind turbines reach their maximum output at a wind speed of 15 m/s.
3 min read
The History of Wind Power Utilization
The ancient wind mills powered irrigation pumps or ground grain. Since 1887, wind power has been used for electricity production in wind turbines.
3 min read
Wind Power Plants
The wind power plants are on the drag principle (historic windmills) or the lift principle (modern turbines). A horizontal or vertical axis is used.
3 min read
Wind Turbine and its Working Principle
The wind turbine transforms the kinetic energy of the flowing air into rotational movements of the rotor blades, which turns the generator.
3 min read
The Largest Wind Farms
The largest onshore wind farm is Roscoe, Texas, USA, with 627 turbines, while the largest offshore wind farm is Thanet, UK, with 100 turbines.
3 min read
Types of Wind Turbines
The wind turbines can have a vertical axis, which is the majority of installations, or a horizontal axis like the Darrieus or Savonius turbines.
5 min read
Wind Turbines and the Environment
A wind power plants produce no emissions or waste, could be a source of noise or strobe effect, are a distinctive landmark, and require large areas.
3 min read